IPv6 Test - Check If Your Connection Supports IPv6
IPv6 test
This site can be reached over both IPv4 and IPv6. The test shows which one your browser actually used and what that says about your connection.
Testing your connection…
IPv6 address format
Analyzed in your browser; nothing is sent. If your connection uses IPv6, your own address is filled in after the test.
IPv6 explained
IPv6 is the newer version of the Internet Protocol. It was created because IPv4 offers only about 4.3 billion addresses, far too few for every phone, computer and connected device. Today most networks run both versions side by side, and your browser picks one for each website.
How the test works
- 1 Your browser contacts this site, which has both an IPv4 and an IPv6 address, and our server reports which version the request arrived on.
- 2 Where available, it also tries addresses that work only over IPv4 and only over IPv6. If one of them is not set up, that step is skipped and the result says so.
- 3 Below the result you can paste any IPv6 address to see its full and short form, its type and its network prefix. No points or scores – just what was measured.
Why IPv6 matters
With 128-bit addresses, IPv6 has enough room to give every device its own public address. That removes the need for shared addresses such as CGNAT, which can break gaming, video calls and remote access. Browsers use the "Happy Eyeballs" method: they try IPv6 first and fall back to IPv4 within a fraction of a second if IPv6 does not answer, so a dual-stack connection is never slower to start.
How to read an IPv6 address
An IPv6 address is eight groups of four hexadecimal digits separated by colons. Leading zeros in a group may be dropped, and one run of all-zero groups may be replaced by "::" – so 2001:0db8:0000:0000:0000:0000:0000:0001 becomes 2001:db8::1. In a typical home network, the first four groups (the /64 prefix) identify your network and come from your provider; the last four (the interface ID) identify the device.
Why your connection may have no IPv6
The most common reasons are that the provider does not offer IPv6 yet, that it is switched off in the router, or that a VPN blocks it. Many routers have an IPv6 option (sometimes called DHCPv6 or prefix delegation) that only needs to be turned on; otherwise ask your provider. Old routers and some company networks support only IPv4.
IPv6, privacy and VPNs
Modern systems use temporary IPv6 addresses for outgoing connections and change the interface ID regularly, so your device is not identified by one fixed address. The network prefix, however, usually stays the same longer. If you use a VPN that only carries IPv4, IPv6 traffic may bypass it and reveal your real address – check with the WebRTC leak test and see whether this page shows your VPN address.